This silcone mold is for making ring caps for the RingMaster System.
To choose your size please add your final ring size plus the number next to your clay from chart below. The total is what number you need. So for example if you need ring size 6 and you are working with PMC3 you add the 3 from chart to final ring size 6+3 = 9.
So you would need to use number 9 from Ring Master Ring Cap Mold 6-9 to make ring cap.
|Using this metal clay||Add this #|
|PMC Onefire 960||4|
|Art Clay Silver||3|
|Art Clay 950||4|
**Ring size shrinkage is approximate for stated clays and may be subject to change
1. Lubricate mold with Cooltools slip or you favorite mold lubricant.
2. Roll 3.5 mm thick or use Rolling frame clay sheet into mold slowly. It should take several passes with roller to fully fill mold.
3. Ring cap needs to be fully dry before remving from mold. About 15-20 minutes using hot plate.
4. To clean hand wash with warm water and dish soap. A tooth brush can be used to clean any clay out of crevices.
RingMaster System Instructions